Anyone know the centre bore size on standard 480 wheels?
Just looking for some hubcentric spacers, there's a few to choose from @ 4x100 pcd!!
Thanks,
Steve
centre bore
Moderators: jifflemon, coyote1980, Rachel
- doingitsideways
- 480 Expert
- Posts: 659
- Joined: Wed May 02, 2012 8:55 pm
- Location: Manchester
centre bore
"If you can't fix it with a hammer, it's an electrical fault!"
Hammers can't fix a 480!!!
Hammers can't fix a 480!!!
Re: centre bore
Hey,
think it was 52,1.
Regards
480 2.0|T
think it was 52,1.
Regards
480 2.0|T
'93 B18FT (190.000 km) - Black Metallic (305)
'93 B20F (102.000 km) - Steel Grey Metallic (319) => RIP
'92 B18FT (249.000 km) - Red (231) => RIP
'95 B20F (220.000 km) - Paris Blue Metallic (318) => RIP
'93 B20F (102.000 km) - Steel Grey Metallic (319) => RIP
'92 B18FT (249.000 km) - Red (231) => RIP
'95 B20F (220.000 km) - Paris Blue Metallic (318) => RIP
- doingitsideways
- 480 Expert
- Posts: 659
- Joined: Wed May 02, 2012 8:55 pm
- Location: Manchester
Re: centre bore
Ok, that gives me something to go on.
Thanks,
Steve
Thanks,
Steve
"If you can't fix it with a hammer, it's an electrical fault!"
Hammers can't fix a 480!!!
Hammers can't fix a 480!!!