480 cambelt cover
Moderators: jifflemon, coyote1980, Rachel
-
- 480 Newbie
- Posts: 35
- Joined: Sat Nov 02, 2002 5:40 pm
- Location: dorset uk
480 cambelt cover
Can anyone help I am after cambelt cover front and back there are three parts to cover front cover 3343732,cover upper 3344548, casing lower 3343735 casing lower is the main one I need but all would be helpful.Any info would be great.
cheers john.
cheers john.
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
Re: 480 cambelt cover
Hi
Lucky you , I have some covers . Must check .
regards
Marek
Lucky you , I have some covers . Must check .
regards
Marek
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
Re: 480 cambelt cover
In my treasures I found two covers , one plastic with Renault part number / 77....../ and second short / metal / without part number . Vadis says that You have B18E , ED , ES , EP , am I right ? You need inner and outer casings . Best for me , send VIN please . I`m charging my camera , so maybe today You will have pictures .
best
Marek
best
Marek
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
Re: 480 cambelt cover
You could use 5mm bolts, drilled through a flat plate to draw the pulley off.
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
Re: 480 cambelt cover
It works but only on a bigger cog , for smaller you need a puller .
-
- 480 Newbie
- Posts: 35
- Joined: Sat Nov 02, 2002 5:40 pm
- Location: dorset uk
Re: 480 cambelt cover
Hi thanks very much for replying to my post I am pleased to say I now have the covers I need.
Cheers
John.
Cheers
John.
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
Re: 480 cambelt cover
someone was before me , no gasket , a lot of silicon , not resistant of diesel fuel and oil !
Covers ! Unfortunately , small plastic cover is cracked , it`s a gift for you . Puller I ordered for a small cog is not suitable , but ... two bolts maybe works , Vadis says..... PULLER !They give only a part number , without a picture .
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland
-
- Can tell where the 480 was built
- Posts: 378
- Joined: Fri Jan 15, 2010 1:20 pm
- Location: Cracow , Poland