Page 1 of 1
Plasma cutter < £80
Posted: Mon Feb 10, 2020 7:08 pm
by Alan 480
Re: Plasma cutter < £80
Posted: Mon Feb 10, 2020 8:16 pm
by jifflemon
nice find!
Re: Plasma cutter < £80
Posted: Tue Feb 11, 2020 7:12 am
by cranna21
I have the better half poised to search all 3 Lidl's on her way home from work in Dyce - old Aberdeen on Thursday
Re: Plasma cutter < £80
Posted: Tue Feb 11, 2020 7:58 am
by jifflemon
I hope she works nights, because stuff like this is normally off the shelves on Listed on Ebay by 9am!
Re: Plasma cutter < £80
Posted: Tue Feb 11, 2020 10:24 am
by cranna21
Ah but there are the joys of low population density Scotland
"They may take our lives, but they will never take our middle aisle bargains!"
Re: Plasma cutter < £80
Posted: Tue Feb 11, 2020 12:56 pm
by Alan 480
jifflemon wrote: ↑Mon Feb 10, 2020 8:16 pm
nice find!
was on the Reliant web forum, usually filed in the 'today at Lidl /Aldi' section . .. . .
cranna21 wrote: ↑Tue Feb 11, 2020 10:24 am
Ah but there are the joys of low population density Scotland
"They may take our lives, but they will never take our middle aisle bargains!"
Good news, so I know where to go if I need some steel cut to fancy shapes???
Re: Plasma cutter < £80
Posted: Tue Feb 11, 2020 1:39 pm
by cranna21
IF i get it aye!
but my work is thinking on installing a CNC plasma table... so then you can have multitudes of fancy cut shapes!!
Re: Plasma cutter < £80
Posted: Thu Feb 20, 2020 12:44 pm
by Alan 480
cranna21 wrote: ↑Tue Feb 11, 2020 1:39 pm
IF i get it aye!
but my work is thinking on installing a CNC plasma table... so then you can have multitudes of fancy cut shapes!!
then you need to programme the CNC rather than just follow the chalk line?
Re: Plasma cutter < £80
Posted: Thu Feb 20, 2020 1:09 pm
by cranna21
i'm qualified in drawing CNC lines, but ironically not chalk lines