Volvo 480 Club Europe

Hi All
I have a stainless steel duplex de-cat exhaust on a j plate turbo,
does any one know if it can be tweeked to fit a 2.0 litre m plate?
Your help would be appreciated as it is only a few months old & cost £450 & some dick head has written the car off!

Cheers Tiny

afraid the pipe size is not the same on the 1.7/1.7turbo/2lt
maybe weld a reducer on?

It is possible to weld a reducer on (I've done it) you may however loose a slight bit of back pressure due to the extra half inch of bore. But it would work with a little modding.

Who was it that made the exhaust in the first place?

If its possible here at HOMD we make it real

Hi guys
Thanks for the info the exhaust was made by performance cars
(powerflow).

Tiny