Page 1 of 1
Exhaust manifold flange
Posted: Mon May 18, 2020 7:35 pm
by schwartz
Does anyone know where/if it's possible to get exhaust manifold flanges to make a tubular manifold?
Re: Exhaust manifold flange
Posted: Mon May 18, 2020 8:59 pm
by jifflemon
For which engine?
Re: Exhaust manifold flange
Posted: Mon May 18, 2020 9:47 pm
by schwartz
Sorry
b18ft
Re: Exhaust manifold flange
Posted: Tue May 19, 2020 3:34 pm
by Alan 480
Assuming that the cylinder heads are the same? then a two litre one could be 'sacrificed' as it is already a flat palte with tubes welded on?
or you could get one water jetted.
I have a spare manifold (two litre) must be a way to get the shape onto a dwg / dwf type file?
or I could attempt it in 'OnShape', although that will probably nae happen . . . . . .
can't get to grips with this 3D stuff