Page 1 of 1
B18U
Posted: Wed Jun 25, 2014 7:24 am
by walker
hi im new i own volvo 440 1.8 single point injection and i was wondering can a mono injection be turbocharged if no what else can i do to make the car run faster .Sorry for bad language im from bulgaria
Re: B18U
Posted: Wed Jun 25, 2014 8:18 pm
by doingitsideways
No, not really.
The compression ratio is too high in the N/A engines, and the management won't support forced induction from a turbo, or supercharger.
Best bet is to get hold of a B18FT and associated wiring loom and ECUs from a car that is being broken, and transplant that in place.
The block is externally almost identical to the one you already have in a B18U, so it would all bolt up very easily
Steve
Re: B18U
Posted: Fri Jun 27, 2014 8:03 pm
by walker
Alright and can i fit this engine in 340 they look almost the same
Re: B18U
Posted: Fri Jun 27, 2014 9:10 pm
by doingitsideways
Yes, definitely possible, and a quite frankly hilarious conversion!
Check out
http://www.volvo300mania.com/uk/forum/ for some inspiration
Steve
Re: B18U
Posted: Fri Jun 27, 2014 11:26 pm
by glasgowjim
Re: B18U
Posted: Sat Jun 28, 2014 10:07 am
by doingitsideways
Ha ha, yeah usually.
They usually use a 360 base as they already run with a 2.0 redblock and torque tube type prop, but there have been a fair few B18FT conversions using a 340 base.
Just need to uprate the standard aluminium prop and be careful on launch to not destroy the gearbox!
There one on ebay actually at the moment...
http://www.ebay.co.uk/itm/1989-VOLVO-34 ... 4ad75e5785
Steve
Re: B18U
Posted: Sun Jun 29, 2014 3:22 pm
by walker
i actualy have one 340 but the car is not in good condition it has a lot stain and dont know if it worths to repair it