Page 1 of 1

DevilsOwn Water/Methanol

Posted: Sat Jan 15, 2011 10:35 pm
by volvo-tom
Today me and my mate daz installed a devilsown kit on my turbo,
( http://cgi.ebay.co.uk/DEVILS-WATER-INJE ... 127wt_1139 ) considering were both just 16yrs old it was surprisingly easy to fit, it took me and my mate about 6hours to fit and test it. The i cant really tell any difference atm but then again all ive had to test it on is a long'ish' drive way lol
Image
Image
(to save the hassle of having to tap into an ignition source i simply placed a toggle switch in the engine bay)
Image
Image
Image
Image
Image
Image
the only problem i had with the kit was locating a vacuum/pressure line, the only way i cud do this was to just randomly pull off pipes in the inlet and see which ones caused the pressure switch to activate when on boost, i used an LED light strip on the bonnet to show me when it was active-
Image
i later found one on the throttle body housing that did just the job
Image
Image

if anyone has any questions feel free to ask!

thanks for looking,
tom

Re: DevilsOwn Water/Methanol

Posted: Mon Jan 24, 2011 8:58 am
by volviz
at what pressure you sat it to activate?

I don't think that you will see any difference while the car is fairly stockish, but certanly will help if further modifications are planned... ;)

Re: DevilsOwn Water/Methanol

Posted: Mon Jan 24, 2011 10:57 pm
by Auk
Hmm, don't want to bother you but your engine is breathing hot air instead of cold air... not really a upgrade, that airfilter..

Re: DevilsOwn Water/Methanol

Posted: Tue Jan 25, 2011 5:25 pm
by volvo-tom
ive got it set to 6psi at the moment, its got a boost controller so the main reason was too reduce the chance of dettonation, it'll also hopefully cool down the intake temps.
I did think about the air filter, but altho u cant see it in the photos it does hav a cold air feed goin to it, and plus i figured surely the intercooler would cool down the air going into the engine anyway :-)

,tom

Re: DevilsOwn Water/Methanol

Posted: Mon Jan 31, 2011 5:57 am
by volviz
one more quick question... I can't quoite understand where the spraying nolse is located, behind air filter?

Re: DevilsOwn Water/Methanol

Posted: Mon Jan 31, 2011 4:22 pm
by volvo-tom
no problem, its located at the front of the inlet manifold, just before the throttle body (after the air filter), i hope this pic helps -
Image

Re: DevilsOwn Water/Methanol

Posted: Tue Feb 01, 2011 7:09 am
by volviz
nice thanks ;)

Re: DevilsOwn Water/Methanol

Posted: Wed Aug 03, 2011 7:42 am
by martinholmesuk
Hi,

I have the same kit on my supercharged mx5. The intake temps have gone right down. In fact the inlet pipe is ice cold. I am using a mix of water and isopropyl (99.7 alcohol)
is your pump higher then the water bottle? I pretty certain the pump should be below.

I run my 5lt tank from the boot.

Martin