So to start:
Pull the mirror glass away from the mirror to release it from its mounting. (its clipped into place) Then remove the two wires for the heated mirror
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0014-1.jpg)
Then unscrew the mirror motor held in place with three screws (this is not essential but allows better access and I was changing my motor anyway)
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0013-1.jpg)
In this case, i needed to remove the motor completly so I had to unlip the connector
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0011-1.jpg)
You can now see the retaining screws for the back trim (the black part) and the clips for the front trim (white part)
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0012-1.jpg)
Remove the trim by unscrewing the 4 screws. (you may need a short screwdriver for this as the quarter window gets in the way) My mirror trim had two broken tabs.
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0009-1.jpg)
Release the front trim by un-hooking the plastic tabs. My mirror cover was fecked! New cover shown as a comparison.
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0006-1.jpg)
When refitting the mirror cover, I lubricated the clips with some silicone spray. This made refitting much easier.
Refitting is reversal of removal blah blah blah....
and the finished article:
![Image](http://img.photobucket.com/albums/v387/Roo/My%20480/DSCF0015.jpg)