Page 1 of 1
440 2.0 Induction kit
Posted: Thu Oct 25, 2007 8:48 pm
by BruceT
Is there a "kit" for the 2.0?
I know you could probably just bolt on a cone filter but just wondered if there was a kit? (For noise and smiles per mile etc)
If not, the JR replacement panel filter will suffice im sure as I have on in my C70 T5 and its all good.
Just curious, dont shoot me
Posted: Thu Oct 25, 2007 9:07 pm
by martinholmesuk
Stick some ducting like this 480 1.7 (B18EP) Sounds very good!
Posted: Thu Oct 25, 2007 10:50 pm
by robkendall
lol....is that a blinky i see before me
what ever happened to matts car?
rgrds
rob
Posted: Sun Oct 28, 2007 9:08 pm
by BruceT
Is there anything else out there?
Or am best to just bodge a cone on there?
Posted: Tue Oct 30, 2007 6:44 pm
by robkendall
if you just bodge a cone on there, then you pretty much defeat the object....
they look kind of nice, but add no perfromance over the original volvo one at all....the volvo airbox and flat panel filter are fine and pretty free flowing anyway.
on a trubo i would probably get a flat panel filter thats more freeflowing, but would still use the volvo box setup.
rgrds
rob
Posted: Tue Oct 30, 2007 6:55 pm
by Dan the 480 Man
On my 440, before i had the chavvy cone filter on, i fed some flexi-tube from the bottom of the air-box and fed it to the front bumper, so the cold air was being taken directly from the front bumper:
Bumpers off obviously, but i made a hole next to the right hand foglight when the bumper was back on. Made no difference at all! Just made the car look cool...i think
Posted: Wed Nov 07, 2007 10:43 pm
by Dan the 480 Man
Jus found the pic with the air feed in the bumper. I took the pipe off from under the airbox, cut off the big bendy bit, cut the end bit off-found some flexi tube, popped the end of the pipe into the flexi, made a whole next to the fog and fixed it in place. Nice and neat, and very chavvy
Air filter made a nice raspy noise though-sounded a bit louder after too...
