Been reading through your pages for quite some time, thanks a lot for all the useful information within this forum
![Smile :)](./images/smilies/icon_smile.gif)
I am currently restoring a smoke grey 480 Turbo to roadworthy condition (well to be honest, it is already more than roadworthy, but having owned a 480 Turbo before, I'd like to address as many points as possible before using it in daily traffic) and one of the things that had to be re-done was the sound system.
The previous owner was a ... is clot the right word? cut off all the tweeter cables, the original speaker connectors, used wire clamps in a lot of wtf-are-they-doing-there-places and so on.
I need to add a separate amp to the new setup, since the radio I will be using (old Clarion unit) doesn't come with an internal amp. My problem is:
This ist a Turbo. With AC. From 1990 (ABS MK2). I could not find any free rubber seals to route the power cable through the firewall, they are all in use by the AC lines etc, the cable looms that enter through the screw-on caps near the windshield are packed full, can't squeeze in a 10²mm there either.
Do you have any recommendation where I might try to route a cable inside so that it is well protected and won't act as an entry point for water?
(LHD car, I'm from the continent ^^ )
Oh, and any advice on how to route new speaker cables inside the doors? Will have to do that, too sadly, the old ones seem to be a bit messed up (and quite thin).
Thanks in advance,
Tobias
(P.S.: My nick comes from owning a 855 T5 ^^ )