Volvo 480 Club Europe

It would cost 60 euros with shipping to the UK so I was wondering if anyone here had some they're willing to sell?

Pictures attached

http://imgur.com/a/hoQRyL3

Good to see you again! Hows the GT?

Do you know anyone with a 3D printer? If so you can print your own

how's the GT

Well, it still drives

Airbag light, both window regulators need replacing, windscreen washer pump and some other stuff.
Should be mostly sorted soon

GCooper wrote: ↑

Wed Jul 14, 2021 3:47 pm

Airbag light, both window regulators need replacing, windscreen washer pump and some other stuff.
Should be mostly sorted soon

Have the regulators snapped? Again you can 3D print a repair kit
If the motors aren't spinning at all, check connections at multi plugs aren't corroded.

Washer pump - For the purpose of MOT, you could swap the front and rear pumps over (rear pump isn't MOT testable).
New pumps aren't expensive though

The right window is completely detached from the regulator and the left gets jammed, I think it's because of a loose cable

GCooper wrote: ↑

Wed Jul 14, 2021 3:55 pm

The right window is completely detached from the regulator and the left gets jammed, I think it's because of a loose cable

That happened to me once (my fault)

But I was able to fix it by threading the metal wire back round the sprocket, but my fingers did not forgive me for a long time!

Send me your address, a very kind 480 driver who's moving house and needed to get rid of stuff has given me a four of these headlight hinges to share amongst the needy!

Postage won't be Skandix-priced: 6 Euro.

MisterH wrote: ↑

Wed Jul 14, 2021 6:07 pm

GCooper wrote: ↑

Wed Jul 14, 2021 3:55 pm

The right window is completely detached from the regulator and the left gets jammed, I think it's because of a loose cable

That happened to me once (my fault)

But I was able to fix it by threading the metal wire back round the sprocket, but my fingers did not forgive me for a long time!

I'll see if I can fix it myself, if not I'll get a new regulator. I haven't looked at the driver side yet, it wasn't a priority because I managed to close it by hand

GCooper wrote: ↑

Wed Jul 14, 2021 3:47 pm

Airbag light,

remove bulb, sorted

If I can't fix it before the MOT this is what I'll do

Alan 480 wrote: ↑

Thu Jul 15, 2021 8:17 pm

GCooper wrote: ↑

Wed Jul 14, 2021 3:47 pm

Airbag light,

remove bulb, sorted

This is what I'm going to do, I've also ordered a 1989 steering wheel with no airbag

You realise you’ll need a few more bits?
Upper column and light stalks are needed too

See Jay K’s post