rear bumper/wiring to fog light
Posted: Sat Dec 19, 2020 8:17 pm
confession time.
When looking at a water leak I found that the spare wheel was nipping the wire against the cross section, no bother I'll just wiggle a bit more cable into the boot, thought being the word to use
is there a gap that the fog light cable should sit in when the bumper is fixed in place? I thought I'd made sure it wasn't trapped but obviously not.
Slackened off the the RHS bolts.(lots of grease over the nuts) and prised it away but can't seem to get it to stay free, even when trying to line it up with the hole inside....
When looking at a water leak I found that the spare wheel was nipping the wire against the cross section, no bother I'll just wiggle a bit more cable into the boot, thought being the word to use
is there a gap that the fog light cable should sit in when the bumper is fixed in place? I thought I'd made sure it wasn't trapped but obviously not.
Slackened off the the RHS bolts.(lots of grease over the nuts) and prised it away but can't seem to get it to stay free, even when trying to line it up with the hole inside....