Hi all,
My car almost sailed through its MOT, only problem is the handbrake. The rear offside cabel is too tight, so it's pulling out of the the securing clip near the back of the cable. This is causing the handbrake to lose all its reserve and so it's failing its brake test. What's the best may to slacken the cable to stop it pulling out of the securing clip?
Handbrake cable too tight?
Moderators: jifflemon, coyote1980, Rachel
- Brasco
- 480 Is my middle name
- Posts: 2400
- Joined: Thu Jan 06, 2005 10:27 pm
- Location: Sat in a barrel of tits, sucking his thumb.
- Contact:
Handbrake cable too tight?
[img]http://img.photobucket.com/albums/v302/Brasco480/myelan3.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/SV400024rip-1.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/fc85e36c.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/SV400044-1.jpg[/img]
- chris1roll
- Friend of Club 480 Europe
- Posts: 3927
- Joined: Wed Feb 12, 2003 6:50 pm
- Location: Using LOTS of petrol!
- Brasco
- 480 Is my middle name
- Posts: 2400
- Joined: Thu Jan 06, 2005 10:27 pm
- Location: Sat in a barrel of tits, sucking his thumb.
- Contact:
Ok. Sorted... put a couple of cable-ties round for good measure.
[img]http://img.photobucket.com/albums/v302/Brasco480/myelan3.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/SV400024rip-1.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/fc85e36c.jpg[/img][img]http://img.photobucket.com/albums/v302/Brasco480/SV400044-1.jpg[/img]