bleeding rear brakes ABS
Posted: Sun Jun 24, 2012 6:32 pm
I put new rigid pipes and flexibles on the NEAR side (UK) 2.0 litre a few weeks back and all OK.
now I did the OFF side and I can't get the pedal worth a **** !!
I would normally use a 'quick' pedal action to push the air along the pipe but if we try this there is a 'woosh' noise and damn all fluid comes out, I suspect it is due to some safety balance thing. the N/S when valve opened gives a nice steady stream but the O/S is just a dribble
I wondered if it was because the O/S goes up OVER the rear axle and getting a bubble there but split it at the join between hose and copper and plenty fluid pours down my arm!
I suspect it is in teh flexible as needs a decent volume to push eh air through.
any ideas welcome?!?!?
now I did the OFF side and I can't get the pedal worth a **** !!
I would normally use a 'quick' pedal action to push the air along the pipe but if we try this there is a 'woosh' noise and damn all fluid comes out, I suspect it is due to some safety balance thing. the N/S when valve opened gives a nice steady stream but the O/S is just a dribble
I wondered if it was because the O/S goes up OVER the rear axle and getting a bubble there but split it at the join between hose and copper and plenty fluid pours down my arm!
I suspect it is in teh flexible as needs a decent volume to push eh air through.
any ideas welcome?!?!?