Gearbox/driveshaft bellows bearing - how to refit
Posted: Wed Feb 14, 2018 10:57 am
Hello, after finding out that the spare driveshaft I have is wrong. I will replace the leaking bearing + bellows boot on my existing driveshaft. Left side.
I don't have a problem to remove/refit the spider/tripod nor to remove the old bearing, but how do I put on the new bearing without damaging it? Any tips? Do i need a press or similar? Tap it back on with a hammer, same way you got it off?
Any suggestions appreciated.
Stephen
I don't have a problem to remove/refit the spider/tripod nor to remove the old bearing, but how do I put on the new bearing without damaging it? Any tips? Do i need a press or similar? Tap it back on with a hammer, same way you got it off?
Any suggestions appreciated.
Stephen