Page 1 of 1

creaky clutch/cable

Posted: Fri Jul 06, 2012 8:22 am
by Rachel
hi....I have a new clutch cable but its very creaky and stiff...when the cable was fitted it was fine for a while then got stiff so i had it adjusted, but it remains stiff and really creaky....i fear it could be part of the clutch but could it be anything else i could check? it doesn't sound internal, just really noisy and annoying :(

Re: creaky clutch/cable

Posted: Fri Jul 06, 2012 9:09 am
by glasgowjim
First locate eact source of the creak.
At first guess I would put it down to the connector between the pedal assembly and the cable. It is a tight/awkward job changing it and the nloc part is quite long , the temptation is to not fully tigten up hence the creak . I have changed one in 15 mins other times it has taken longer but if the mechanic was a bit tubby then it is a difficult job for them (upside down head at pedals job with small hands a nust :rofl: :rofl: )

Re: creaky clutch/cable

Posted: Fri Jul 06, 2012 9:11 am
by glasgowjim
oh and dont lose the bolt it is a special one for that component.

Re: creaky clutch/cable

Posted: Fri Jul 06, 2012 10:24 am
by Rachel
cheers Jim....so what exactly would i be looking for and where? obviously down by clutch pedal...will it be fairly obvious when down there? these kind of jobs are where being a woman can be a bonus...smaller hands! ;)

Re: creaky clutch/cable

Posted: Sat Jul 28, 2012 3:38 am
by piper1st
Hi Rachel

Does it happen all the time, or only happen when cold/hot? Really obvious, but have you tried locating the squeek (as Jim said), then applying a little 3in1 oil? Could be an easy 1 minute fix? :wink:

Re: creaky clutch/cable

Posted: Sun Jul 29, 2012 8:27 am
by heavend
Taking the driver's seat out can make life easier. I'm going to guess that the noise is coming from the nylon sleeve/bolt that the clutch pedal rotates on.