Page 1 of 1
382 Ohm
Posted: Sat Jul 14, 2012 8:11 am
by evothinker
I was wondering if somebody could tell me how tu adjust MAF. everybody says that between pin 1 and 6 must be 382 Ohms but NOBODY DID TELL IF THERE MUST BE THIS VALUE WITH THE ENGINE TURNED OFF OR ON. So please help! Thanks i advance!
Re: 382 Ohm
Posted: Sat Jul 14, 2012 1:01 pm
by glasgowjim
With the engine off .
Re: 382 Ohm
Posted: Sat Jul 14, 2012 8:21 pm
by evothinker
are you sure?
Re: 382 Ohm
Posted: Sun Jul 15, 2012 9:58 am
by chriskay
evothinker wrote:are you sure?
If you're not prepared to believe the answer, why ask the question?
Re: 382 Ohm
Posted: Sun Jul 15, 2012 12:20 pm
by Robou
What actually is believed is nonsense, looking into the question. An answer to correct this has already been given in a different thread. Probably been read in disbelief.
Re: 382 Ohm
Posted: Sun Jul 15, 2012 1:08 pm
by glasgowjim
The thread is "MAF regulation" and Robou has answered the question fully.
Evothinker you have been given all the info you need.