hello
my 480 s had died!
is had been sluggist to start for a while
i replaced the useuall plugs points etc
and it ran a little better but know nothing!
so far ive replaced crank censor, the coil, renix unit
the ecu and still no joy!
the car turns over but there is no spark to the plugs
any help or sujestiosn before it goes to the scrappers
would be more that greatfully recived!
jude
help 480 wont start
Moderators: jifflemon, coyote1980, Rachel
try looking at crank sensor, check with a AC volt meter, disconeect it and chack the voltage when spinning over, you should get a slight A?C voltage as the flywheel spins past the sensor when cranking.
See if you have a spark fron the coil before the dist cap, if you have it could be a faulty rotor or cap, cheap fix,
What year and engine is it???
See if you have a spark fron the coil before the dist cap, if you have it could be a faulty rotor or cap, cheap fix,
What year and engine is it???
- glasgowjim
- 480 Is my middle name
- Posts: 4830
- Joined: Sun Oct 01, 2006 5:28 pm
- Location: GLASGOW SCOTLAND
Often when a 480 starts to run sluggish and deteriorate it is due to muck from the engine getting into the distributor . Check this first before going mad about the car trying to check everything under the sun . keep it simple. Easy obvious stuff first then if no solution move onto the next level
clean out and with a bit of sandpaper clean the deposits formed on the cap connections inside the cap. Then remove your spark plugs to see if they are not all gunged up ! If they are clean or replace .[/u]
Oops see you have done this already DOH
how about the ignition leads?
engine earths?
clean out and with a bit of sandpaper clean the deposits formed on the cap connections inside the cap. Then remove your spark plugs to see if they are not all gunged up ! If they are clean or replace .[/u]
Oops see you have done this already DOH
how about the ignition leads?
engine earths?
-
- Advanced 480 rookie
- Posts: 509
- Joined: Mon May 04, 2009 2:53 pm
.
i second the the earth strap. my mother had a mini wouldnt start. garage had fitted starter and were about to fit new alternator.i put new earth lead and problem gone.check it by running a piece of largeish wire from battery-
to a clean spot on the engine.
to a clean spot on the engine.