Volvo 480 Club Europe

I have two TPS sensors for the 2.0 engine: one old Bosch and a newer "unnamed". On Bosch the resistance is about 870–2500 Ohm (from closed throttle to fully open). On the unnamed one it is 1100-2600 Ohm. I have read somewhere that the correct resistance should be 1000-2500 Ohm. Can someone confirm t...

I also have a problem with my info centre, so I will join this thread. Whenever I start the engine, my info centre seems to get a reset in terms of average speed and average fuel consumption. Once the car is running, everything is ok and the averages are being calculated. They are also being shown a...

You can rise them manually using a white knob at the end of the popup motor. Just be patient, it takes some time

Apart from wires around the temperature sensor, it is quite common that the wires between the seat and the backrest break. As others said, start with measuring the resistance to find the faulty part (as far as I recall it should be something around 1.5 Ohm for each half of the seat). Just remember t...

That calls for some good 3D printing designer!

I am very curious about the outcome of this project Keep us updated and good luck!

Yes, it's already advertised for parts on facebook group: https://www.facebook.com/groups/5381186515/

I can see the whole gauge set with the sensor and the bracket in this eBay auction: https://www.ebay.com/itm/192032858258 The price is a bit high...

Does anyone know if the bracket can be replaced by some non-original part? It seems to be a fairly simple part

Nice I think it looks very good.

You need brave pills, then you pull the rotary headlight switch, yes.Its not the knob, but the whole assembly that comes out, by the way I think that the proper way of removing the round light switch is to remove the knob first. Then it is possible to press two small plastic "levers" which release ...

I had similar symptoms and it turned out to be a broken wire to one of the injectors. At least I hope so, because I have just finished fixing the wire and I will make a test drive tomorrow

Let me dig up this old topic—I have a question related to it

It seems that my keyhole illumination is always on. Should it be like that? I am a bit worried that it is slowly draining my battery

Did anyone of you tried installing one of these senders? Do they fit?

3D printing is the only hope for 480 owners