Search found 20 matches
- Tue Feb 24, 2009 7:25 am
- Forum: Engine (20)
- Topic: Remove snapped off bleed screw
- Replies: 17
- Views: 4413
- Wed Feb 04, 2009 12:21 pm
- Forum: Engine (20)
- Topic: DIP Stick???
- Replies: 3
- Views: 1330
- Mon Feb 02, 2009 1:30 pm
- Forum: Power transmission (40)
- Topic: 27 mpg....how do i improve this...
- Replies: 13
- Views: 9302
- Mon Feb 02, 2009 12:15 pm
- Forum: Power transmission (40)
- Topic: 27 mpg....how do i improve this...
- Replies: 13
- Views: 9302
- Sun Feb 01, 2009 10:13 pm
- Forum: Electrical system (30)
- Topic: Diagnostic system
- Replies: 12
- Views: 4500
hi. Thanks for the reply! I've seen both those pages before, but my problem is that when I push the button, no matter which socket I put the pin in, it gives me no LED light. Previously, none of the sockets worked except the ABS part, which gave me a clean 1-1-1. Now with a new ECU (read: used) none...
- Sun Feb 01, 2009 1:55 pm
- Forum: Electrical system (30)
- Topic: Quick question about washer pump spec
- Replies: 2
- Views: 1331
- Sun Feb 01, 2009 1:54 pm
- Forum: Electrical system (30)
- Topic: wiring diagram
- Replies: 2
- Views: 1387
- Sun Feb 01, 2009 1:52 pm
- Forum: Electrical system (30)
- Topic: ECU's and loom.. Do they need to be same year ?!
- Replies: 2
- Views: 1289
Ooh.. I just have a 460, but I've swapped my ECU, and if you don't have both an exact volvo parts number and a siemens number, it will potentially give you a world of pain. For my car it's about 20 different ECUs, and only a couple will work at most. And probably not those with most matching numbers..
- Sun Feb 01, 2009 1:50 pm
- Forum: Electrical system (30)
- Topic: My First Post-A super geeky question
- Replies: 3
- Views: 1634
I just replaced mine with a scrapped one, fixed most of my problems. Is your battery bad or something? If you're concerned about this, you should run 50mm2 wires from alternator to battery, use a proper power splitter, and maybe upgrade some wiring and go over the earthing here and there.. Things co...
- Sun Feb 01, 2009 1:47 pm
- Forum: Electrical system (30)
- Topic: Info Centre engine temperature always cold.
- Replies: 5
- Views: 2661
Hold your horses there, mate. There has been reported problems with corrosion and bad contacts on the analogue gauges of the volvos with renault engines. Also, I've seen busted gauges alot. Both the analogue fuel gauge and the temp gauge should read 50 ohm, and you should spray the brass nuts giving...
- Sun Feb 01, 2009 1:44 pm
- Forum: Electrical system (30)
- Topic: Diagnostic system
- Replies: 12
- Views: 4500
- Sun Feb 01, 2009 1:43 pm
- Forum: Electrical system (30)
- Topic: Windscreen washer pump - 480S 1993
- Replies: 5
- Views: 1776
I bought a brand new one in the norwegian store Biltema. Cost me less than 8gbp (and remember, everything is more expensive over here). Pretty much everything will work. My tube into the tank had a bit too small dimension, I just used some duct tape around it and forced it in, now it works like a ch...
- Sun Feb 01, 2009 1:41 pm
- Forum: Electrical system (30)
- Topic: Rev counter
- Replies: 1
- Views: 1009
- Sun Feb 01, 2009 1:36 pm
- Forum: Engine (20)
- Topic: Fuel consumption variation - sensor issue?
- Replies: 13
- Views: 3426
- Sun Feb 01, 2009 1:35 pm
- Forum: Engine (20)
- Topic: Remove snapped off bleed screw
- Replies: 17
- Views: 4413
This kinda happened to me, the dsc adn the screw bit kinda snapped off, and only the valve itself was left. Fixed it with sandpapering a plastic cork, putting it upside down. Used plastic welding to weld it to the part i snapped off. Made four holes for strips to come through it on the side, so that...
- Sun Feb 01, 2009 1:30 pm
- Forum: Engine (20)
- Topic: Which model volvos have b18f engine?
- Replies: 3
- Views: 1608
- Sun Feb 01, 2009 1:29 pm
- Forum: Engine (20)
- Topic: Bad idle at cold engine.
- Replies: 6
- Views: 2054
- Sun Feb 01, 2009 1:27 pm
- Forum: Engine (20)
- Topic: Consequence of failure to bleed coolant system
- Replies: 7
- Views: 2580
I've been noticing that under the carpet in my rhs footwell, there is moist under the carpet.. But I never understood where it came from. Perhaps my heater matrix is leaky? It also has air bubbles, but without the airing screw, how can I bleed the system properly? Try to just squeeze the hose until ...
- Sun Feb 01, 2009 1:22 pm
- Forum: Engine (20)
- Topic: The sound of flowing water behind dash lol
- Replies: 5
- Views: 1620
- Mon Nov 24, 2008 6:52 pm
- Forum: Parts, Accessories & Brochures
- Topic: Wanted: ECU
- Replies: 1
- Views: 753
Wanted: ECU
My ECU doesn't seem to be grounding the fuel pump relay and the relay next to it.. So they won't click, and i get no power to fuel pump, so it won't start.
The numbers are: 472948/02.
Anyone have one?
The numbers are: 472948/02.
Anyone have one?