Search found 54 matches

by AleksanderHugo
Mon May 25, 2020 7:09 pm
Forum: Electrical system (30)
Topic: High co2 emissions 480 2.0
Replies: 15
Views: 5603

Re: High co2 emissions 480 2.0

Yes, actually... both lambda sensors were fine ;) I had it replaced by a rather incompetent workshop that used to swap parts before properly diagnosing the problem. You can check a couple of things: - unplug the sensor and check the resistance between the signal wire towards the ECU and the ground, ...
by AleksanderHugo
Sun May 24, 2020 4:16 pm
Forum: Electrical system (30)
Topic: High co2 emissions 480 2.0
Replies: 15
Views: 5603

Re: High co2 emissions 480 2.0

I had a problem like this. Similarly as the dcwalker said, the shielded wire between lambda sensor and the ECU fails with time. In my case the insulation between the shield (which is grounded) and the signal wire was broken. Due to this, the signal at the ECU was close to zero all the time and the E...
by AleksanderHugo
Sat Apr 25, 2020 8:52 pm
Forum: General Discussions
Topic: Blinky 51/480
Replies: 437
Views: 222420

Re: Blinky 51/480

The dot at the slider knob? Yes, it is illuminated by two T5 bulbs placed at both ends of the slider. These also illuminate all the labels (“A/C, etc.). It is possible to replace them by pulling off the knob and then carefully removing the front plastic panel (no need to open the dashboard).
by AleksanderHugo
Mon Mar 30, 2020 6:16 pm
Forum: General Discussions
Topic: First 480, first real project car
Replies: 73
Views: 17416

Re: First 480, first real project car

Isn't it an aircon compressor plug?
by AleksanderHugo
Mon Jan 27, 2020 9:17 pm
Forum: General Discussions
Topic: First 480, first real project car
Replies: 73
Views: 17416

Re: First 480, first real project car

I think the lights shouldn’t be completely sealed. There are few “ventilation openings” — at least one on the back of the unit and one at the bottom. They allow air to circulate around the light, so it can dry out.
by AleksanderHugo
Wed Dec 04, 2019 7:29 am
Forum: Electrical system (30)
Topic: Extreme Speedo Rescue
Replies: 21
Views: 7978

Re: Extreme Speedo Rescue

My only idea: could it be that one of the speedo wires has broken insulation and it is grounded somewhere accidentally?
by AleksanderHugo
Wed Dec 04, 2019 6:56 am
Forum: Engine (20)
Topic: Overheating...coolant temperature too high...STOP!
Replies: 16
Views: 9975

Re: Overheating...coolant temperature too high...STOP!

I have tried a spare MFU module and it behaved exactthe same. I think that the IC works as follows: Pin 10 is a reference ground for the IC. Let’s assume that there is, for example, 0.3V across the temp sensor at some given temperature. If Pin 10 is at the same electrical potential as the engine blo...
by AleksanderHugo
Tue Dec 03, 2019 5:10 pm
Forum: Engine (20)
Topic: Overheating...coolant temperature too high...STOP!
Replies: 16
Views: 9975

Re: Overheating...coolant temperature too high...STOP!

Thanks James — you were right. The IC measurements are relative to a dedicated ground wire, which — in case of my 1994 car — is Pin 10 (Brown-Blue wire) of the grey connector to the instrument cluster. I measured voltage between the negative terminal of the battery and that Pin 10 (with the engine r...
by AleksanderHugo
Tue Dec 03, 2019 4:45 pm
Forum: Body and Interior (80)
Topic: 480ES boot seal leaking
Replies: 20
Views: 8992

Re: 480ES boot seal leaking

I also have a small issue with moisture in the boot. I am not sure if the seal is the main reason, but after 25 years, it's pretty worn out and not too flexible. Moreover, whenever it rains and I open the boot, there is some water that drips from the seal straight onto my luggage. Today I installed ...
by AleksanderHugo
Wed Nov 06, 2019 6:12 am
Forum: Body and Interior (80)
Topic: Bulbs for instruments
Replies: 12
Views: 4475

Re: Bulbs for instruments

The seventh bulb is hidden inside of the ventilation fan switch :) but it’s not easy to replace as it’s not in a socket but it is soldered with some thin wires.
by AleksanderHugo
Fri Oct 18, 2019 8:37 pm
Forum: Engine (20)
Topic: Overheating...coolant temperature too high...STOP!
Replies: 16
Views: 9975

Re: Overheating...coolant temperature too high...STOP!

New developments in my overheating story. I made some inconclusive tests with a laser thermometer — temperature seemed lower than IC display, but I wasn't really sure where to measure it exactly on the engine :? Then, I decided to test the info centre, which was the only thing that no one looked int...
by AleksanderHugo
Wed Oct 09, 2019 6:23 pm
Forum: Engine (20)
Topic: Overheating...coolant temperature too high...STOP!
Replies: 16
Views: 9975

Re: Overheating...coolant temperature too high...STOP!

I am still struggling with the overheating. As suggested, I verified that the cooling fan works when bridged. Then, I took the car to two workshops and got plenty of things done: - new thermostat, - new 1-pin temperature sensor for Info Center display, - new 3-pin temperature sensor for the cooling ...
by AleksanderHugo
Wed Aug 28, 2019 7:01 am
Forum: Engine (20)
Topic: Overheating...coolant temperature too high...STOP!
Replies: 16
Views: 9975

Re: Overheating...coolant temperature too high...STOP!

My 480 developed overheating issue as well. It showed “STOP” for the first time about three weeks ago. The car went to a workshop, where they did not find any problems... I hate these issues that appear and disappear randomly :( I was observing the temp reading for few days — it is usually between 8...
by AleksanderHugo
Fri May 10, 2019 9:17 am
Forum: The Wastegate (Off Topic)
Topic: 1992 Renault Master Camper Van For Sale
Replies: 7
Views: 5196

Re: 1992 Renault Master Camper Van For Sale

Since it’s a Renault, are you able to transfer its engine into a 480? :wink:
by AleksanderHugo
Sat May 04, 2019 9:22 pm
Forum: Electrical system (30)
Topic: Mysterious connectors hanging underneath the car
Replies: 6
Views: 2517

Re: Mysterious connectors hanging underneath the car

The two loose connectors could be for the signal horn. There were two horns fitted as standard, so perhaps you are missing one?
by AleksanderHugo
Thu Apr 25, 2019 12:13 pm
Forum: Howto manuals
Topic: Illuminated window switch
Replies: 4
Views: 4510

Re: Illuminated window switch

Perhaps it can be done simpler :) I wasn’t sure how to remove/add pins without damaging the base, so I decided to move the LED instead :)

I guess that your solution gives the same result apart from turning off the LED while the window is going down automatically (minor difference).
by AleksanderHugo
Mon Apr 22, 2019 10:04 am
Forum: Howto manuals
Topic: Illuminated window switch
Replies: 4
Views: 4510

Illuminated window switch

Taking advantage of a free afternoon, I decided to upgrade the window switches on my 480 and illuminate them. I had a pair of switches from a Volvo 440, but after a closer inspection it turns out that these are slightly different. Volvo 440/460 does not have the "fancy features" of automatic opening...
by AleksanderHugo
Mon Apr 22, 2019 7:30 am
Forum: Spotted!
Topic: 480 with sliding vinyl sunroof in Haarlem, Netherlands
Replies: 12
Views: 6299

Re: 480 with sliding vinyl sunroof in Haarlem, Netherlands

I think that some company (Westfalia perhaps) used to make these aftermarket roofs.

Once I came across a photo of a 480 with such a roof:
Image
by AleksanderHugo
Thu Apr 11, 2019 5:33 am
Forum: Spotted!
Topic: Launch car Found!
Replies: 39
Views: 11407

Re: Launch car Found!

Looks great! I especially like the combination of black bumpers with colored lip :)
by AleksanderHugo
Tue Apr 02, 2019 9:04 am
Forum: Howto manuals
Topic: How to fix the speedometer cable connector
Replies: 16
Views: 12685

Re: How to fix the speedometer cable connector

Wouldn’t it be better to install some better connector instead? Removing it completely seems like a no-return option :)